Kenwood DNX520VBT Installation Manual page 4

Connection
Connector Function Guide
Pin Numbers for Cable Colour
ISO Connectors
External Power
Connector
A-4 Yellow
A-5 Blue/White
A-6 Orange/White
A-7 Red
A-8 Black
Speaker
Connector
B-1 Purple
B-2 Purple/Black
B-3 Gray
B-4 Gray/Black
B-5 White
B-6 White/Black
B-7 Green
B-8 Green/Black
Connector A
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
Connector B
⁄ Connect to the vehicle's parking brake
detection switch harness.
Parking sensor wire (Light Green)
Connect to the terminal that is grounded when either
⁄
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
⁄
4
|
DNX520VBT
Functions
Battery
Power Control
Dimmer
Ignition (ACC)
Earth (Ground) Connection
Rear Right (+)
Rear Right (–)
Front Right (+)
Front Right (–)
Front Left (+)
Front Left (–)
Rear Left (+)
Rear Left (–)
Battery wire (Yellow)
Ignition wire (Red)
(Orange/White)
PRK SW
For the sake of safety, be sure to connect the parking sensor.
Connect to vehicle's reverse lamp harness when
using the optional rear view camera.
⁄ To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
the telephone rings or during conversation.
To connect the Kenwood navigation system,
consult your navigation manual.
If no connections are made, do not let the cable come out from the tab.
Dimmer control wire (Orange/White)
Reverse sensor wire (Purple/White)
Steering remote control wire
(Light Blue/Yellow)
To steering remote
Mute control wire (Brown)
Power control/ Motor antenna control wire
(Blue/White)
FM/AM antenna
Antenna Cord
input (JASO)
ILLUMI