Paper Loading - Intermec PB40 Quick Start Manual

Paper Loading

Out of Paper
The PB40 Printer sounds two quick beeps when it runs out of
paper. If the printer is out of paper, the printer suspends opera-
tion until paper is present and the lever is down. The printer
continues to communicate with the mobile computer as long as
it does not "time out." Once the printer restarts, it finishes the
rest of the print job from where it left off.
Removing Paper Core from your PB40 Printer
1 Unsnap the latch and lift up the cover.
2 Wrap your index finger around the empty paper core and pull
up. The paper rod will snap out.
3 Remove the empty paper core and discard.
Paper Loading
Standard Paper
If you are using standard paper, you can load the paper auto-
matically or manually. Experiment to find out which method is
best for you.
Liner'ed Labels
If you are using liner'ed paper, it is best to use the manual paper
loading method.
Automatic Paper Loading
1 Press the red self-test button to wake the printer.
2 With the loose, clean edge of the paper coming from the bot-
tom of the roll, insert the edge of the paper between the roller
and the platen.
3 Pushing the button again while the printer is awake causes
the mechanism to feed about one inch of paper.
4 Insert the paper into the paper well with it resting on the pa-
per rod clips.
Manual Paper Loading
1 Lift up the paper release lever. This takes the pressure off the
platen. Make sure you have a clean edge on the new paper
roll.
2 Take the edge of the paper and fold it 45 degrees.
6 PB40 Printer Quick Start Guide