JVC KS-T807 Service Manual page 6

3.1.4 Removing the side panel
(See Fig.5)
• Prior to performing the following procedure, remove the front
panel assembly as required.
(1) Remove the two screws C and screw D attaching the side
panel on the left side of the main body, and remove the side
panel.
3.1.5 Removing the rear bracket
(See Fig.6)
• Prior to performing the following procedure, remove the bottom
cover.
(1) Remove the two screws E, screw F and three screws G at-
taching the rear bracket on the back side of the main body.
(2) Remove the rear bracket.
3.1.6 Removing the main board
(See Figs.6 and 7)
• Prior to performing the following procedures, remove the front
panel assembly, bottom cover and side panel.
• Remove the front chassis assembly as required.
(1) Remove the two screws E attaching the rear bracket on the
back side of the main body. (See Fig.6.)
(2) Remove the two screws H attaching the main board. (See
Fig.7.)
(3) Disconnect the connector
the main body and take out the main board with the rear
bracket. (See Fig.7.)
Reference:
Remove the rear bracket from the main body as required. (See
"3.1.5 Removing the rear bracket".)
1-6 (No.MA069)
CP401 on the main board from
C D
Side panel
Fig.5
E
Rear bracket
Fig.6
H
CP401
Fig.7
C
G
F G
G E
Main board
H