Searching for a station manually:
Manual search
1
Select the band (FM1 – 3, AM).
FM1
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
2
Press and hold ¢
until "M" (manual) starts flashing on
the display.
3
Tune in to a station you want while
"M" (manual) is flashing.
To tune in to stations of lower frequencies
• If you release your finger from the button,
the manual mode automatically turns off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing—in 50 kHz intervals
(87.5 MHz — 108.0 MHz for FM 1 and FM
2), in 30 kHz intervals (65.00 MHz — 74.00
MHz for FM 3) and 9 kHz for AM—MW/LW
until you release the button.
8
Each time you press the
button, the band changes as
follows:
FM2
FM3
AM
or 4
To tune in to stations of
higher frequencies
When an FM stereo broadcast is hard to
receive:
1
Press M MODE to enter the
functions mode while listening to
an FM stereo broadcast.
2
Press MO (monaural), while still in
the functions mode, so that the
MO indicator lights up on the
display.
Each time you press the button,
the MO indicator lights up and
goes off alternately.
MO (monaural) indicator
When the MO indicator is lit on the display, the
sound you hear becomes monaural but the
reception will be improved.