Turning Your Area(S) On And Off; Entering Your Access Code - DSC PC6010 User Manual

Turning Your Area(s) ON and OFF

This section describes how to turn your areas of the system ON and OFF. You will only be
able to turn on or off the areas which have been assigned to you. All users should read
this section carefully.
Remember - you can return to the start screen at any time by pressing
However, pressing
in, or to re-enter areas, you must enter your access code and turn the areas off.

2.1 Entering Your Access Code ______________________________________________________

Before you can use any system features, you need to enter your access code. The keypad
always displays the start screen first:
12:00 2000/01/01
Step
1.
Enter Your Code
If you enter a valid code, the keypad gives 3 short beeps, and the keypad displays the
next prompt. For example, the keypad may display:
Do You Want To
Turn Areas On?
If the Code is Not Valid
Step 2. If you enter a code that is not valid, the keypad gives one long beep, and the system
prompts:
Code Not Valid
Please Try Again
After 2 seconds, the keypad goes back to the start screen:
12:00 2000/01/01
Enter Your Code
Step 3. Enter your code. If you enter a valid code, the keypad gives 3 short beeps, and the
system prompts:
Do You Want To
Turn Areas On?
If the Code is Valid
Step
4. Answer
finished. Refer to the procedures in this manual for more information on each prompt.
S E C T
will not prevent areas from being turned on. To remain
Enter your access code using the number pad.
Go to step 4 (if the code is valid).
or to each of the keypad prompts until you have
I O N
5
2
.