Step 6 Removing The Pulley Assembly And Drive Belt; Step 7 Removing The Foot Plate - CYBEX 600H HIKER Service Manual

2 / D
ISASSEMBLY
Fig. 2-9
Fig. 2-10
Fig. 2-11
Fig. 2-12
8
WARNING: Be sure that tension from the linkage system has
been released prior to further disassembly.
STEP 6-Removing the Pulley Assembly and Drive
Belt
Must complete at least Steps 1,2-Disassembly.
(Tools required–One 1/8" Allen wrench, one 1/4" Allen wrench, one
9/16" wrench.)
1. Grasp the tension spring and pull down. (See figures 2-8
and 2-9.) Then slip the loop off of the spring shaft.
2. Remove two 1/4" set screws from each of the belt retainers
at foot plate.
3. Slide the drive belt out through the pulley assembly.
4. Remove the 1/2 x .625" long shoulder screw.
5. Remove the pulley assembly. (See figure10.)
WARNING: Be sure that tension from the linkage system has
been released prior to further disassembly.
STEP 7-Removing the Foot Plate
Must complete at least Step 2-Disassembly.
(Tools required–One flat head screwdriver, one rubber hammer.)
1. Remove the two retaining rings on the foot plate which
attach the foot plate to the rear pivot arm assembly. (See
figure 2-11.)
2. Remove the retainer from the foot plate tie rod found in rear
of pedal.
3. Slide the seven wear washers (not shown in figure), foot
plate and the belt attachment assembly off. This may require
a tapping with a rubber hammer.