Installation; Installation Place - Midea Air Conditioner Installation Manual

4. INSTALLATION

4.1 Installation place

The indoor unit should be installed in a location that meets
the following reauirements:
There is enough room for installation and maintenance.
The ceiling is horizontal, and its structure can endure the
weight of the indoor unit.
The outlet and the inlet are not impeded, and the
influence of external air is the least.
The air flow can reach throughout the room.
The connecting pipe and drainpipe could be extracted out
easily.
There is no direct radiation from heaters.
This air-conditioner shold install on the 3m high ceiling.
≥1500
Floor
4.2 Preperaration of installation
4-2-1 The position relation graph of the ceiling opening and the hanging screw.
Water pump outlet
Electronic expansion
valve inspection hole
Water inlet hole and the water
level switch inspection hole
Lifting lug
Liquid side connecting pipe
Air side connecting pipe
Maintenance water outlet
installation manual
4
Installing the equipment in any of the following places may lead to
faults of the equipment (if that is inevitable, consult the supplier):
A. The site contains mineral oils such as cutting lubricant.
B. Seaside where the air contains much salt.
C. Hotpring area where corrosive gases exist, e.g., sulfide gas.
D. Factories where the supply voltage fluctuates seriously.
E. Inside a car or cabin.
F. Place like kitchen where oil permeates.
G. Place where strong electromagnetic waves exist.
H. Place where flammable gases or materials exist.
I. Place where acid or alkali gases evaporate.
J. Other special environments.
Ceiling
≥1500
CAUTION
≥100
Indoor unit
Fresh air connector
Both sides reserved air outlet
Lifting lug
Panel
≥100
Fig.4-1
Fig.4-2