Optional Accessories; Installation Considerations; Table 2-1 - Crimp Tool For Table 2-2 - Crimp Tool For - Garmin GNS 480 Installation Manual

Installation Procedures
2.3.2 O
PTIONAL
For a list of optional accessories that are available but not supplied with the GNS 480, refer to Appendix F.
2.4 S T
PECIAL OOLS
Some of the connectors use crimp contacts. The tables below identify crimp tools required to ensure
consistent, reliable crimp contact connections for the rear D-sub connectors. The tables define one source
for the crimp tool. Alternate equivalent tools may be used.
Description
Insertion/Extraction tool CIET-22D
Crimp tool
Positioner
Description
Insertion/Extraction tool CIET-20HD
Crimp tool
Positioner
Below is the contact for ITT/Cannon crimp tools:
ITT Cannon
666 E. Dyer Road
Santa Ana, CA 92705-5612
2.5 I
NSTALLATION
Installation of this STC does not change the types of approved airplane operations as defined by FAR
23.1525 (e.g. IFR, VFR, day or night). If a change in approved operations is desired, additional aircraft
approvals or inspections will be required.
2.5.1 M
INIMUM
2.5.1.1 VFR Installation
The minimum GNS 480 installation requires the following items for a VFR Installation:
•
GNS 480 GPS/WAAS/Nav/Com (installed in the aircraft manufacturer approved location)
•
GPS antenna, Nav antenna and Com antenna.
•
To take full advantage of the GNS 480 capabilities an optional altitude source is recommended for
automatic sequencing of course-to-altitude (CA) and heading-to-altitude (VA) leg types. If no
altitude data is provided to the GNS 480, CA and VA legs must be manually sequenced.
Without an external CDI, no glideslope information is obtainable. However, the unit will maintain full
VOR and Localizer functionality including an internal CDI display.
The installation must be placarded "GPS LIMITED TO VFR USE ONLY" in clear view of the pilot.
2.5.1.2 IFR VOR/LOC/GS Installation
The minimum GNS 480 installation requires the following items for an IFR VOR/LOC/GS Installation:
•
GNS 480 GPS/WAAS/Nav/Com (installed in the aircraft manufacturer approved location)
2-2
A N
CCESSORIES OT
R
EQUIRED
Table 2-1 - Crimp Tool for P/N 162-0082
ITT/Cannon P/N
271-7048-000
995-0001-584
N/A
Table 2-2 - Crimp Tool for P/N 245-0027
ITT/Cannon P/N
980-200-426
995-0001-584
995-0001-604
Phone (714) 557-4700 or 1-800-854-3028
FAX (714) 628-2142
C
ONSIDERATIONS
S C
YSTEM ONFIGURATION
560-0982-01 Rev A
S
UPPLIED
Military number
M81969/14-01
M22520/2-01
M22520/2-09
Military number
M81969/39-01
M22520/2-01
M22520/2-08
GNS 480 (CNX80) Installation Manual