Wall-Mounting Procedure - Panasonic UB-7325 Installation Manual

Optional Wall-mounting Kit (KX-B063)

■ Wall-mounting procedure

1 Confirm that the wall is strong enough to support the weight of the electronic board.
Caution
The wall must be capable of supporting at least
2,108N [215 kgf (474 lbs.)] for UB-7325.
2 Tape the Wall-mounting template on the wall.
• Do not use the template included in the wall-mounting kit (KX-B063), but rather the one included with
the electronic board (UB-7325).
• When taping the template on the wall, make sure it is level.
3 1) Drill holes in the wall for the wall-mounting fixtures (8 holes total).
• Holes on the wall-mounting fixture are 7 mm (
2) After removing the wall-mounting template, attach the wall-mounting fixtures
with the appropriate wall-mounting hardware (two screws in each fixture).
* This hardware must be locally procured, it is not included in the kit.
• Refer to the section "Attaching the wall-mounting fixtures" (page 15) for drilling in the wall and attaching the
mounting fixtures.
• Refer to step 3 on page 5 for mounting the electronic board.
14
1
Wall-mounting
fixture L
Wall-mounting
hardware*
1
Wall-mounting
fixture L
Wall-mounting
hardware*
1
/ ") in diameter.
4
Wall-mounting template
(provided with UB-7325)
2
Wall-mounting
fixture R
Center of the
electronic board
(See page 3.)