Table of Contents
Advertisement
Installation - Page 9
4.4.
Install the Convector Box
a) Attach the self adhesive foam strip along the sides and top of the outer edge of the convector box at the rear.
b) Hook the spillage plate over the top edge of the firebox as shown in figure 6 and secure using the 2 No.6 x 9.5mm
screws from the bag of fittings.
c) Position the convector box up against the outer metal surround. The bottom air box and upper spigot will locate inside
the combustion chamber front cover and flue hood extension on the boiler.
d) Using 4 of the M5 x 10mm screws from the bag of fittings, securely fasten the convector box to the outer metal
surround. Ensure that the foam strip has been compressed.
4.5.
Assemble and Install the Burner Tray
a) Mount the Blanking Panel on to the Burner Tray using the 4 location screws.
b) Insert the Burner Tray into the convector box so it locates onto the studs at the front.
c) Using the wing nuts, secure the Burner Tray to the convector box.
d) Connect the inlet tube to the gas fire isolation tap. If necessary, the screws securing the isolation tap mounting bracket
can be loosened to allow slight movement when aligning the tube to the tap. Fully tighten the screws once the pipe has
been connected to the isolation tap.
e) Set the isolation tap to the On position, turn ON the gas supply and test the installation and all joints for gas soundness
then purge the installation in accordance with BS 6891.
5. Installing the Firebed Components - Page 9
Install the Vermiculite, Ceramic 'Coal Bed' and Ceramic
Coals as shown in the instruction sheet titled "Installing the
Firebed Components" (Part No. 966/9350/3) supplied with
the ceramic packs.
After installing those components return to these instructions
and carry on with the installation from Section 6.
Hide quick links:
Advertisement
Table of Contents
