Table of Contents
Advertisement
4. Installation - Page 6
4.2.
Install the Surround and Controls
a) Stand the outer metal surround on the hearth and position up against the wall.
b) Ensure it is central about the fireplace opening and mark the 4 positions of the mounting holes on the wall.
c) Remove the surround, then using a 6 mm masonry drill, drill and plug the 4 marked mounting holes on the wall.
d) Attach the foam strip along the sides and top of the surround at the rear.
e) Using the 4 woodscrews supplied, secure the surround to the wall. Ensure the foam strip has been compressed.
f)
Remove from the bag of fittings and secure the tap mounting bracket to the outer metal surround using the 2 M4 x 8mm
screws supplied.
g) Insert the gas fire isolation tap through the hexagonal opening in the tap mounting bracket located at the bottom right of
the surround and secure to the bracket using the locknut. Connect the gas fire supply pipe to the isolation tap. Ensure
the isolation tap is in the closed position.
h) Unplug the user control from the electronic control box on the boiler. Insert the 2 screws supplied into the user control,
feed the cable through the opening and locate the user control against the two slots in the surround. Tighten the screws
sufficiently to hold the control in place.
j)
Connect the user control plug onto its socket on the electronic control box and secure the harness using the cable clips.
Insert the boiler overheat thermostat wire into the cable clips.
4.1.
Unpack the Fire
The fire is supplied in 2 packs.
Pack 2 of 2 contains:-
1
The Convector Box.
2
Burner Tray.
3
Spillage Plate.
4
Outer Metal Surround.
5
Ceramics Pack.
6
Control Board Mounting Bracket.
7
Bag of Fittings.
8
Poly Bag containing these Instructions and other
literature.
Pack 1 of 2 contains:-
a
The Facia Assembly.
b
The Plinth Assembly.
c
Blanking Panel.
d
Poly Bag containing
4 location screws.
If any parts are damaged or missing please contact the
phone number shown on the check lists supplied with the
packs.
DO NOT discard the packaging until all items are accounted
for or the fire is installed.
Hide quick links:
Advertisement
Table of Contents
