4.16 FL Inverter Board
Removing the FL Inverter Board
To remove the FL inverter board, follow the steps below and refer to Figure 4-45.
1.
Turn off the power to the computer, then disconnect the AC adapter and all external
cables connected to the computer.
2.
Remove the battery pack, optional memory module, optional PC card, and display
mask as described in Sections 4.2, 4.3, 4.4, and 4.15.
3.
Remove two M2.5x6 screws securing the FL inverter board.
4.
Carefully rotate the FL inverter board out from right to left and disconnect the
input cable from CN1 and the HV cable from CN2.
Note: You may wish to place a binder and form pad under the display to
provide additional stability while performing these steps.
710CDT/720CDT
Figure 4-45 Removing the FL inverter board
4-47