Toshiba 710CDT Maintenance Manual page 155

4.10 Display Assembly, Jack Board, Speaker, and Modem Board
Removing the Display Assembly, Jack Board, Speaker, and Modem Board
To remove the display assembly, sound board, jack board, speaker, and modem board follow
the steps below and refer to Figures 4-26 to 4-33.
1. Turn off the power to the computer, then disconnect the AC adapter and all external
cables connected to the computer.
2. Remove the battery pack, optional memory module, optional PC card, FDD or CD-
ROM drive, HDD, upper cover and keyboard, and DAA module as described in
Sections 4.2 through 4.9.
3. Turn the computer upside down and remove two M2.5x6 silver screws from the
battery pack slot, two M2x3 screws from the selectable bay, and three M2.5x20
silver screws from the computer base.
4. Turn the computer right side up and open the display.
5. Remove two M2.5x6 screws securing the LCD cable brace.
6. Remove one silver M2.5x20 screw and one M2.5x4 screw securing the metal
cover over the left speaker. The M2.5x4 screw also secures a ground cable.
Remove the left speaker.
7. Disconnect the speaker cable from PJ6 on the jack board and remove the right
speaker.
4-28
Figure 4-26 Removing the screws
710CDT/720CDT