Subaru LEGACY 2004 Service Manual page 117

(3) Move the engine horizontally until main
shaft is withdrawn from clutch cover.
(4) Slowly move the engine away from engine
compartment.
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil level gauge, etc.
26) Remove the front cushion rubbers.
B: INSTALLATION
1) Install the front cushion rubbers.
Tightening torque:
⋅
35 N m (3.6 kgf-m, 25.8 ft-lb)
2) Position the engine in engine compartment and
align it with transmission.
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil level gauge, etc.
3) Apply a small amount of grease to splines of
main shaft. (MT model)
4) Tighten the bolts which hold upper side of trans-
mission to engine.
Tightening torque:
⋅
50 N m (5.1 kgf-m, 36.9 ft-lb)
5) Remove the lifting device and wire ropes.
6) Remove the garage jack.
7) Install the pitching stopper.
Engine Assembly
Tightening torque:
T1: 50 N
T2: 58 N
8) Remove the ST from converter case. (AT model)
NOTE:
Be careful not to drop the ST into the converter
case when removing the ST.
ST 498277200
9) Install the starter. <Ref. to SC(H4SO 2.0)-6, IN-
STALLATION, Starter.>
10) Install the torque converter clutch to drive plate.
(AT model)
(1) Tighten the bolts which hold torque convert-
er clutch to drive plate.
(2) Tighten other bolts while rotating the engine
using a socket wrench.
CAUTION:
LU-00222 Be careful not to drop bolts into the torque con-
verter clutch housing.
Tightening torque:
25 N
(3) Clog the service hole plug and prevent for-
eign matters from being mixed.
ME-00216 11) Install the power steering pump on bracket.
(1) Install the power steering pump on bracket,
and tighten the bolts.
ME(H4SO 2.0)-33
⋅
m (5.1 kgf-m, 36.9 ft-lb)
⋅
m (5.9 kgf-m, 42.8 ft-lb)
T2
STOPPER SET
⋅
m (2.5 kgf-m, 18.1 ft-lb)
MECHANICAL
T1
ME-00218
ME-00212