To Clean The Burner Grates, Contoured; Burner Pans, Burner Cap And Burner Base; Cleaning The Self-Clean Oven - Frigidaire Gallery Series Owner's Manual

General Cleaning
To Clean the Burner Grates, Contoured Burner Pans, Burner Cap and Burner
Base
(continued)
Do not operate the
burners without the burner base and
the burner cap in place.

Cleaning the Self-Clean Oven

Adhere to the following cleaning precautions:
- Allow the oven to cool before cleaning.
- Wear rubber gloves when cleaning any exterior parts of the oven manually.
During the self-clean cycle, the outside of the wall oven can become very hot to the touch. DO NOT leave small children
unattended near the appliance.
Before cleaning any part of the oven, be sure the electronic oven control is turned off or else push CANCEL pad. Wait until
the oven is cool.
DO NOT use commercial oven cleaners or oven protective coatings in or around any art of the self-cleaning oven. DO NOT clean the oven
door gasket. The gasket on the oven door is essential for a good seal. Care should be taken not to rub, damage or move the gasket. DO
NOT cooking or foil could melt and damage the oven surface.
A self-cleaning oven cleans itself with high temperatures (well above cooking temperatures) which eliminate soil completely or reduce it to
a fin powdered ash you can which away with damp cloth.
(continued)
To Clean the Burner Cap
Use a soap-filled scouring pad or a mild abrasive cleanser to clean burner caps and trim
rings. If necessary, cover difficult spots with an ammonia-soaked paper towel for 30 to
40 minutes. Rub gently with a soap-filled scouring pad and rinse with a mixture of clean
water and vinegar. Wipe dry. Remove all cleaners or the porcelain may become damaged
during future heating.
To Clean the removable Burner Base and Gas Opening
The ports (or slots) around the burner base must be routinely cleaned. Use a small-
gauge wire or needle to clean small slots or holes.
Note: If the electrode is damaged or broken, the surface burner will not light. Manual
lighting with a match is still possible.
For proper flow of gas and ignition of the burner—DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS OPENING. Gas must
flow freely through the small hole in the brass orifice for the burners to light properly. If
the orifice gas opening becomes soiled or clogged, use a small-gauge wire or needle to
clean. ALWAYS keep the burner cap assembly in place whenever a surface burner is in
use.
To Replace the Burner
Make sure the pieces are dry before placing back on the burner.
1. Replace burner base at it place. Put back burner cap. Make sure each burner cap is
properly aligned and level.
2. Turn the burner on to determine if it will light. If the burner does not light after
cleaning, contact an authorized servicer. Do not service the sealed burner yourself.
(some models)
General
13
information