Draytek Vigor2960 Series User Manual page 301

Username
Password
Polling Status
Polling Interval
Apply
Cancel
4 . 1 1 . 1 .
4 . 1 1 . 1 .
This page allows you to configure the basic settings for the VPN tunnel of Vigor2960.
Available parameters are listed as follows:
Item
WAN Profile
Local IP/Subnet
IPsec Security Method
Vigor2960 Series User's Guide
Type a username which will be used by any CPE tried to
connect to Vigor router.
Type a password which will be used by any CPE tried to
connect to Vigor router.
Enable – Click it to enable the polling function.
Disable – Click it to disable the polling function.
Type the time value (unit is second). The range is from 60 ~
86400.
Click it to save the configuration.
Click it to discard the settings configured in this page.
2 V P N G e n e r a l S e
2 V P N G e n e r a l S e
Description
Choose a WAN interface profile to be used.
Type the IP address and subnet mask of local host.
Choose one of the following methods for the security of data
transmission. For example, choose AH to specify the IPSec
protocol for the Authentication Header protocol. The data
will be authenticated but not be encrypted.
t u p
t u p
293