Cutter Unit - Brother QL-650TD User Manual

6
Hold the knob and carefully remove the

cutter unit.

Take care not to touch the blade of cutter.
7
Insert the new cutter unit into the appropriate position.
8
Tighten the screw which holds the cutter
unit in place.
9
Install the DK Roll and close the DK Roll cover.
For details, refer to
Replacing the lithium clock battery
A lithium battery is supplied in order to maintain the settings for the internal clock when
the printer unit is not plugged-in to a normal power supply. If the clock settings are reset
every time the printer unit is unplugged from its normal power source, then the battery
must be replaced.
For the lithium battery for replacement, purchase CR2032 (recommended manufacturer:
Hitachi Maxell, Ltd., FDK Corporation, Matsushita Electric Industrial Co.,Ltd., Sony
Corporation, Toshiba Corporation and VARTA Microbattery Inc.).
• Use only the authorized battery for the printer.
•
Dispose in accordance with all applicable federal,
state, and local regulations.
•
When storing or discarding the battery, wrap it with
adhesive cellophane tape etc. to prevent it from short-
circuiting.
•
It is recommended to replace the battery every two
years.
1
Turn OFF the power of this printer and pull the power cord out of the
outlet.
"Installing the DK Roll" in page 23.
Example of grounding of battery
Adhesive cellophane tape etc.
Battery
51
STEP
1
STEP
2
STEP
3