Table of Contents
Advertisement
Chapter 9
Function Mode
The Function Mode includes parameters that allow you to change the behavior of the entire instrument globally.
The following are available parameters in Function Mode:
● Transpose
● Effect Level
● Touch Sensitivity
● Tune
● MIDI Channel
● Metronome
● Rec Rhythm
● Local Control
● Auto Power Off
● Auto Power Off Time
● Hard Reset
● OS/Object
Selecting and Saving Function Parameters
Press the Function button to enter Function Mode. Pressing the Select▲ or ▼ button allows you to choose
one of the parameters listed above. Once you choose a parameter, you will use the Prev- or +Next buttons to
navigate the values of that parameter. Pressing the Function button a second time will exit this mode.
Transpose
The Transpose parameter allows you to adjust the overall pitch of the keyboard up or down in semitone intervals.
Press the the Select▲ or ▼button until the screen displays Transpose:0,
which is the factory default. To transpose the pitch up, press the +Next button
for each semitone up in pitch. To lower or transpose down, Press the Prev- but-
ton to lower the semitone pitch. Pressing the Prev- +Next button pair will reset
the Transposition back to factory default of 0. The transposition has a range of
-24 to +24. This offers a two octave transposition range up or down.
Effect Level
The Effect parameter controls the level of the reverb effects used on a voice.
Press the Select▲ or ▼button until the screen reads EFFECT LEVEL:20
(factory default). To increase the reverb effect, press the +Next button for
your desired effect. To lower or reduce the reverb effect press the Prev- button.
You can adjust the effect level from 0% (no effect) to 100%. Pressing the Prev-
/ +Next button pair will reset the effect level back to factory default of 20%.
page 34
TRANSPOSE: 0
EFFECT LEVEL
: 20
Advertisement
Table of Contents
