Edit From A Camcorder - JVC HR-VP675U Instructions Manual

46
EN
Edit From A
Camcorder
Recorder
AUDIO
IN
VIDEO IN
Camcorder
Player
NUMBER "0"
1
MENU
Your VCR
To rear panel PAUSE/AV
COMPULINK connector
Mini-plug cable (not supplied)
(JVC camcorder only)
Audio/Video cable
(not supplied)
VIDEO OUT
AUDIO OUT
EDIT
CH
0
4
OK
SHUTTLE PLUS
You can use a camcorder as the player and your VCR as the
recorder.
MAKE CONNECTIONS
1
Connect an AV cable between the camcorder's VIDEO
OUT and AUDIO OUT connectors and your VCR's
VIDEO IN and AUDIO IN connectors.
When a Master Edit Control-equipped JVC camcorder is
used, the camcorder is capable of controlling your VCR.
The mini-plug cable is a mono 3.5 mm mini-plug to
mono 3.5 mm mini-plug connector.
If connecting to a camcorder with a monaural output,
connect the audio output connector on the
camcorder to AUDIO IN L of the VCR.
LOAD A CASSETTE
2
Insert the cassette to be recorded on into the recorder.
SELECT "EDIT" FOR PIC-
TURE CONTROL SET MODE
3
Follow the "Picture Control" section on page 26, then
select "EDIT."
NOTE:
When you select "EDIT" to dub tapes, be sure to select
AUTO or (NORM when VIDEO CALIBRATION is set to
OFF) after you finish dubbing the tapes.
SET RECORDER'S INPUT
MODE
4
Set to "AUX". Press the NUMBER key "0" and/or CH to
select depending on the connector being used – "L-1"
for the rear AUDIO/VIDEO IN connectors, or "F-1" for
the front AUDIO/VIDEO IN connectors.
If you're using a JVC Master Edit Control-equipped
camcorder — step 5
If not — step 8
ACCESS MAIN MENU
SCREEN
5
Press MENU.
ACCESS FUNCTION SET
SCREEN
6
Press CH 5 ∞ or SHUTTLE PLUS % fi to move the
highlight bar (arrow) to "FUNCTION SET", then press OK
or SHUTTLE PLUS
EDITING (CONT.)
.