Diting; Edit To Or From Another Vcr - JVC HR-VP675U Instructions Manual

EDITING
Edit To Or
From Another
VCR
Player
AUDIO OUT
VIDEO IN
Recorder
4
7
NUMBER "0"
1
Your VCR
R
L
VIDEO OUT
Audio/Video cable
(not supplied)
AUDIO IN
Another VCR
CH
5 6
8 9
0
4
CH
PLAY
You can use your VCR as the player or the recorder.
MAKE CONNECTIONS
1
Connect an AV cable between the player's VIDEO OUT
and AUDIO OUT connectors and the recorder's VIDEO
IN and AUDIO IN connectors.
When using your VCR as the recorder and a monaural
VCR as the player, connect the player's AUDIO OUT
connector to the AUDIO IN L connector on the recorder.
LOAD CASSETTES
2
Insert the playback cassette into the player and the
cassette to be recorded on into the recorder.
SET RECORDER'S INPUT
MODE
3
Set to "AUX". With this VCR, press the NUMBER key "0"
and/or CH to select depending on the connector being
used – "L-1" for the rear AUDIO/VIDEO IN connectors,
or "F-1" for the front AUDIO/VIDEO IN connectors.
SELECT "EDIT" FOR PIC-
TURE CONTROL SET MODE
4
Follow the "Picture Control" section on page 26, then
select "EDIT."
NOTE:
When you select "EDIT" to dub tapes, be sure to select
AUTO or (NORM when VIDEO CALIBRATION is set to
OFF) after you finish dubbing the tapes.
START PLAYER
5
Set to its play mode.
NOTE:
If the player is equipped with a superimpose/OSD
disable feature then set "SUPERIMPOSE" to OFF before
pressing PLAY (
START RECORDER
6
Set to its record mode.
EN
pg. 29).
45