Editing; Edit From A Camcorder - JVC HR-S9850EU Instructions Manual

EDITING

Edit From A
Camcorder
A
If the camcorder has no S-VIDEO output connector ...
Recorder
VIDEO
AUDIO
input
input
(not provided)
Video cable (not provided)
VIDEO OUT
Camcorder
AUDIO OUT
EDIT
Player
B
If the camcorder has an S-VIDEO output connector ...
Recorder
AUDIO
input
S-VIDEO
Audio cable (not provided)
input
S-Video cable (provided)
S-VIDEO OUT
Camcorder
AUDIO OUT
EDIT
Player
To rear panel
PAUSE/R.A.EDIT
connector
Audio cable
Mini-plug cable
(not provided)
(JVC camcorder
only)
To rear panel
PAUSE/R.A.EDIT
connector
Mini-plug cable
(not provided)
(JVC camcorder
only)
You can use a camcorder as the source player and your
recorder as the recording deck.
A
Make connections.
A If the camcorder has no S-VIDEO output connector ...
... connect the camcorder's AUDIO OUT and VIDEO
OUT connectors to the recorder's front panel AUDIO
and VIDEO input connectors.
B If the camcorder has an S-VIDEO output connector ...
... connect the camcorder's AUDIO OUT and
S-VIDEO OUT connectors to the recorder's front panel
AUDIO and S-VIDEO input connectors.
When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your recorder.
When a Master Edit Control-equipped JVC camcorder is used,
the camcorder is capable of controlling the recorder. Refer to
the camcorder's instruction manual for operating procedure.
B
Set the recorder's input mode.
Press AUX (number key "0") and/or PR to select "F-1" for
the AUDIO and VIDEO input connectors, or "S-1" for the
AUDIO and S-VIDEO input connectors, depending on
the connectors being used.
C
Set the edit mode.
See "PICTURE CONTROL" on page 69.
D
Start the camcorder.
Engage the Play mode of the camcorder.
E
Start the recorder.
Engage the Record mode of the recorder.
NOTES:
All necessary cables can be obtained from your dealer.
When you select "EDIT" to dub tapes in step 3, be sure to
select "AUTO" (or "NORM" when "B.E.S.T." is set to "OFF")
after you finish dubbing the tapes.
51
EN