Dell OptiPlex 390 Mini-Tower Owner's Manual page 80

Error Message
Bad command or file name
Bad error-correction code (ECC) on disk
read
Controller has failed
Data error
Decreasing available memory
Gate A20 failure
General failure
Hard-disk drive configuration error
Hard-disk drive controller failure
Hard-disk drive failure
Hard-disk drive read failure
Invalid configuration information-please
run SETUP program
Invalid Memory configuration, please
populate DIMM1
80
Description
Ensure that you have spelled the
command correctly, put spaces in the
proper place, and used the correct path
name.
The hard drive controller detected an
uncorrectable read error.
The hard drive or the associated controller
is defective.
The hard drive cannot read the data. For
the Windows operating system, run the
chkdsk utility to check the file structure of
the hard drive. For any other operating
system, run the appropriate corresponding
utility.
One or more memory modules may be
faulty or improperly seated. Re-install the
memory modules and, if necessary,
replace them.
One or more memory modules may be
faulty or improperly seated. Reinstall the
memory modules and, if necessary,
replace them.
The operating system is unable to carry
out the command. This message is usually
followed by specific information—for
example, Printer out of paper. Take the
appropriate action to resolve the problem.
The hard drive failed initialization.
The hard drive failed initialization.
The hard drive failed initialization.
The hard drive failed initialization.
The computer configuration information
does not match the hardware
configuration.
DIMM1 slot does not recognize a memory
module. The module should be re-seated
or installed.