Dodge 2014 Ram 1500 User Manual page 123

NOTE:
If the EVIC displays "DID NOT TRAIN" repeat from Step 2.
5. At the garage door opener motor (in the garage), locate the "LEARN" or
"TRAINING" button. This can usually be found where the hanging antenna wire
is attached to the garage door opener motor. Firmly press and release the
"LEARN" or "TRAINING" button.
NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has
been pressed.
6. Return to the vehicle and press the programmed HomeLink
the button for two seconds each time). The EVIC will display "CHANNEL #
TRANSMIT". If the garage door opener/device activates, programming is complete.
NOTE:
If the device does not activate, press the button a third time (for two seconds) to
complete the training.
7. To program the remaining two HomeLink
remaining button. DO NOT erase the channels.
Programming A Non-Rolling Code
NOTE:
For programming Garage Door Openers manufactured before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
3. Simultaneously press and hold both the HomeLink
and the hand-held transmitter button.
4. Continue to hold buttons until the EVIC display changes from "CHANNEL #
TRAINING" to "CHANNEL # TRAINED", then release both buttons.
5. Press and hold the programmed HomeLink
light.
NOTE:
If the EVIC displays "DID NOT TRAIN" repeat from Step 2.
• To program the two remaining HomeLink
remaining button. DO NOT erase the channels.
ELECTRONICS
button twice (holding
®
® buttons, repeat each step for each
indicator light in view.
®
® button you want to program
button and observe the indicator
®
® buttons, repeat each step for each
®
121