Dodge 2014 Ram 1500 User Manual page 122

ELECTRONICS
Before You Begin Programming
HomeLink®
• Ensure that your vehicle is parked out-
side of the garage before you begin
programming.
• For efficient programming and accurate
transmission of the radio-frequency sig-
nal, it is recommended that a new bat-
tery be placed in the hand-held trans-
mitter of the device that is being
programmed to the HomeLink
• Erase all channels before you begin
programming. To erase the channels,
place the ignition switch into the ON/
RUN position, then press and hold the
two outside HomeLink
indicator flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink
the first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–3515
or, on the Internet at www.HomeLink.com for information or assistance.
Programming A Rolling Code
NOTE:
For programming Garage Door Openers that were manufactured after 1995. These
Garage Door Openers can be identified by the "LEARN" or "TRAIN" button located
where the hanging antenna is attached to the Garage Door Opener. It is NOT the
button that is normally used to open and close the door. The name and color of the
button may vary by manufacturer.
1. Place the ignition switch into the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
3. Simultaneously press and hold both the Homelink
and the hand-held transmitter button.
4. Continue to hold buttons until the EVIC display changes from "CHANNEL #
TRAINING" to "CHANNEL # TRAINED", then release both buttons.
120
system.
®
buttons (I and III) for up to 20 seconds or until the red
®
® indicator light in view.
® button you want to program
® for
®