Input Channel; Storing Channels Manually - JVC HR-S6722EK Instructions Manual

48
NUMBER
1
MENU

Storing Channels Manually

To store channels that were not stored during Auto Set Up
( pg. 8), Preset Download (
( pg. 46).
ACCESS MAIN MENU
1
Press MENU.
ACCESS CONFIRMATION
SCREEN
2
Press %fi to move the highlight bar (pointer) to
"MANUAL CH SET", then press OK or
mation screen appears.
SELECT POSITION
3
@ #
Press % fi
until an
open position in which
you want to store a
channel begins blinking,
then press OK. The Manual
Channel Set screen
appears.
– –:– –
3
1 2
2
4
5 6
8 9
7
4
0
?
OK
pg. 9) or Auto Channel Set
#
. The Confir-
(Ex.) To store in position 6.
PR CH ID
01 26 BBC1 08
02 33 BBC2 09
03 23 ITV
04 30 CH4
05 37 CH5
06 –––– 13
07 –––– 14
[ 5 ∞
]
=
: EDIT
= [X] : DELETE
[MENU] : EXIT
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
SUBSIDIARY SETTINGS (cont.)
SELECT BAND
4
Press % fi to change the
band between CH (regular)
and CC (cable), then
press

INPUT CHANNEL

5
Press the NUMBER keys to
input the channel number
you want to store.
ENTER NEW CHANNEL
INFORMATION
6
Press OK and the Confirmation screen appears.
CLOSE CONFIRMATION SCREEN
7
Press MENU.
ATTENTION
Guide Program numbers are not set when channels are
stored manually. If an attempt is made at timer program-
PR CH ID
ming with the VIDEO Plus+ system in this state, the
––––
"GUIDE PROG SET" screen appears; set the Guide
––––
10 ––––
Program numbers on this screen.
11 ––––
Regarding Guide Program Number Set" on page 19.
12 ––––
––––
Or perform "Guide Program Number Set" (
––––
#
.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
To input the registered
station name (ID –
#
pg. 51), press until
"– – – –" (ID setting)
begins blinking, then
press %fi.
The blueback screen and the
For fine tuning
programme currently being
#
adjustment, press
broadcast by the selected channel
until "+/–" begins
appear alternately for 8 seconds
blinking, then press
each.
%fi. While tuning,
"+" or "–" appears.
When "L-2 SELECT" is set to "A/V" or "SAT", the
"DECODER" setting cannot be changed (
Repeat steps 3 through 6 as necessary.
To change positions, see "Change Station Preset
Position" ( pg. 49).
If you wish to set station names other than the ones
registered in your recorder,
page 50.
PR CH ID FINE DECODER
06 CH01 – – – – +/– OFF
[ 5 ∞ ] : SELECT
] : CURSOR +=
[
: OK
[MENU] : EXIT
PR CH ID FINE DECODER
06 CH21 – – – – +/– OFF
[ 5 ∞ ] : SELECT
] : CURSOR +=
[
: OK
[MENU] : EXIT
pg. 36).
"Set Stations (B)" on
"ATTENTION –
pg. 43).