Table of Contents
Advertisement
3
In the wireless client utility, go to the WPS setting page. Enable WPS and press the Wifi button
(Start or Wifi button).
4
Push and hold the Wifi/WPS button located on the VDSL Router's rear panel for 10 seconds.
Note: It doesn't matter which device's button you press first. You must press the second
button within two minutes of pressing the first one.
Note: The WPS button in the Web Configurator screens also has the same function as the
one on the VDSL Router rear panel: use either.
The VDSL Router sends the wireless network settings to the wireless client. This may take up to two
minutes. Afterwards the wireless client can communicate with the VDSL Router securely.
The following figure shows an example of how to set up a wireless network and its security by
pressing a button on both VDSL Router and wireless client.
Example WPS Process: PBC Method
Wireless Client
PIN Configuration
When you use the PIN configuration method, you need to use both the VDSL Router's web
configurator and the wireless client's utility.
1
Launch your wireless client's configuration utility. Go to the WPS settings and select the PIN method
to get a PIN number.
Basic Home Station VDSL2 P8701T User's Guide
WITHIN 2 MINUTES
SECURITY INFO
COMMUNICATION
Chapter 2 User Setup Guide
VDSL Router
Wifi/WPS
Press and hold for
10 seconds
25
Advertisement
Table of Contents
