Vivotek Supreme FE817V User Manual page 12

VIVOTEK
Ceiling/Wall Mount with Mounting Plate
(Choose this mounting type if you would like to feed the cables form the side)
1� Attach the supplied alignment sticker for the supplied mounting plate to the ceiling/wall�
2� Using the three circles on the sticker, drill three holes into the ceiling� Then hammer the
three supplied plastic anchors into the holes�
3� Arrange and feed the cables through the side of the mounting plate�
4� Secure the mounting plate to the ceiling/wall with three supplied screws�
5� Connect the Ethernet cable to the socket�
6� Connect two white pin header connectors to the J6 and J7 connectors�
7� Attach the camera base to the mounting plate and turn counter-clockwise as shown below
(Figure 7-1). Then secure the supplied screw to fix the camera base.
8. You will find a moisture absorber attached to the camera. Replace the moisture absorber
with the one shipped within the accessory bag�
9� Attach the dome cover�
10� Secure the four screws with the supplied stardriver� Make sure all camera parts are securely
installed�
2
1
12 - User's Manual
3
4
7
7-1
7-2
10
9