Majestic Vemont Castings RHE25 Installation Instructions & Homeowner's Manual page 36

Vermont Castings, Majestic Products RHE Natural Vent Insert
Bottom
Decorative
Plate
Fig. 61 Slide bottom decorative plate under unit floor.
RHE42FP Replacement Parts
FP1292
bottom channel
1
2/03
2
3
4
Vermont Castings, Majestic Products reserves the right to make
changes in design, materials, specifications, prices and discontinue
colors and products at any time, without notice.
IMPORTANT: Only trim panel assemblies approved
FP1296
RHE32
by Vermont Castings, Majestic Products can be
flat trim
used on these products.
2/03
ALL repair parts will be available from your local dealer.
When ordering, always give the following information:
Model and serial number, part description with finish
and part number.
Key Description
1 Trim Window Top/Bottom
2 Plate Decorative Bottom
3 Top Louvre Assembly (Metallic Black)
4 Bottom Louvre Assembly
(Metallic Black)
5 Hinge
6 Hardware Package (Not Shown)
36
FP1292
5
6
FP1296
RHE42FP
10000880
10000915
10000929
10000930
52356
57916
C3 RHE42BTKP
For use with RHEDV42
RHE42BTKP Bay window with polished brass trim
Do not remove existing glass with frame.
Trim Assembly
1. Reposition controls.
a. Remove the Fan Speed Control Box. (Fig. 62)
b. Attach the Fan Speed Control Box to the Bracket
(Fig. 61) and install the Bracket into the Cabinet.
Only for RN/RP VALVE units:
c. Install the Control Knob Extensions onto the ap-
propriate Control Valve Knobs. (Fig. 64)
On units fitted with a Honeywell brand control
valve the location of the control knobs and
the ignitor button may vary slightly from those
shown in Figure 64. The Honeywell extension
pieces are visually different in design and are
not interchangeable with the RN/RP knobs
shown in Figure 64.
2. Install the hanging brackets. (Fig. 65)
3. Install the two (2) ceramic pieces inside the bay
window.
4. Install the bay window by hanging it onto the lower
tabs of the hanging brackets. (Fig. 66)
5. Install top louvre by engaging the oblong holes with
the upper tabs of the hanging brackets. (Fig. 67)
6. Install brass trim to the steel frame. (Fig. 68)
Fan Control Box
Fig. 62 Remove fan control box.
Fan Control
Box
Extension
Bracket
Fig. 63 Attach the control box to the bracket and install
bracket into the cabinet.
KT205
KT205
Bay Front
remove fan control box
3/19/01 djt
KT207
KT207
10000836
Bay Front
attach fan control box
HEDV30/HEDV32
3/19/01 djt