Majestic Vemont Castings RHE25 Installation Instructions & Homeowner's Manual page 35

1. Install trim channels (left and right sides) by remov-
ing the two (2) screws that hold the side brass trim
and put them back to hold both parts.
2. Slide on the trim top channel and fasten it from the
back side.
3. Remove the two (2) screws that hold the top brass
trim.
4. Install the two (2) brackets to the studs in the bottom
of the top channel. Use the nuts supplied with the
kit.
5. Reinstall the two (2) screws to hold the top trim
channel.
A flat louvre kit OR a bay window kit need
to be chosen to complete the installation.
RHE42SSP & RHE42LP Replacement Parts
5 3
Vermont Castings, Majestic Products reserves the right to make
changes in design, materials, specifications, prices and discontinue
colors and products at any time, without notice.
IMPORTANT: Only Trim Panel Assemblies Approved by
Vermont Castings, Majestic Products Can Be Used on These
Products.
ALL repair parts will be available from your local dealer.
When ordering, always give the following information: Model
and serial number, part description with finish and part
number;
Key Description
1 Frame Trim Kit
(Metallic Black)
2 Trim Top Channel
3 Trim Side Channel
4 Trim Top Channel
5 Trim Side Channel
6 Fasteners Package
(Not Shown)
7 Trim Top Deflector
(1) LP trim to be used with SSP trim.
SSP trim dimensions are for openings smaller than 30³⁄₄" H x 42⁷⁄₈"W
(781mm x 1089mm)
LP trim dimensions are for openings smaller than 33³⁄₁₆"H x 48"W
(846mm x 1225mm)
10000836
Vermont Castings, Majestic Products RHE Natural Vent Insert
4
5
3
2
1
7
FP1297
FP1297
RHE42
Trim parts
2/03
RHE42SSP RHE42LP (1)
10000931 -
57508 -
57509 -
- 57511
- 57507
54618 -
10000912 -
C2 RHE42FP Trim
For use with RHEDV42
RHE42FP Flat face louvres with polished window
brass trim
Trim Assembly
1. Remove the front glass (Refer to "Glass Frame Re-
moval" section).
2. Install top and bottom brass trim (Fig. 59 & Fig. 60)
Use the shortest black screw.
4. Install bottom decorative plate by simply sliding it
under the unit. No fastening is required for this in-
stallation. (Fig. 61) Be sure to remove the protective
plastic cover from the trim.
5. Install the bottom louvre assembly by fastening the
hinges with four (4) screws to the pre-punched holes
in the cabinet.
6. Re-install the front glass.
7. Install the top louvre assembly by using the hooks to
hang it in place.
Trim Top
Glass Frame
Trim Bottom
Fig. 59 Install support window trim channel and top and
bottom brass trim.
Louvre
NOTE: Position
brass trim top as
shown (small end
up) to prevent heat
discoloration.
Glass Frame
Fig. 60 Position brass trim to with small end up.
Screws
FP1295
FP1295
RHE32
window trim
2/03
FP1291
FP1291
RHEDV
glass trim top
2/03
35