Alcatel OmniAccess 600- series Quick Start Manual page 22

re-enter password: new_pass
Passwords are case-sensitive and must be a minimum of three to a maximum of eight characters. For future reference,
make a note of the password that you use.
Changing the Administrator Account Name
You can change the administrator login name (Level 1 access) to a user-specified name. The default is Alcatel.
The following commands change the administrator account name to Greg:
Alcatel> configure term
Alcatel/configure> admin_name Greg
Configuring the Date and Time
Date and time are set using the configure date and the configure utc commands.
To configure the date, enter the month, day, and year. For example, to set the date to April 30, 2005, enter:
Router/configure> date 04 30 2005
To set the current time for the router in Universal Time Coordinated time, specify the time zone offset ahead (+) or
behind (-) the time in Greenwich England), the number of hours ahead or behind Greenwich time, and the number of
minutes ahead or behind the time in Greenwich.
For example, to set the local Pacific Standard Time to UTC time, enter:
Router_LA/configure> utc - UTCHours 8
Configuring an Ethernet IP Address and Subnet Mask
Alcatel> configure term
Alcatel/configure> interface ethernet 0
Alcatel/configure/interface/ethernet 0> ip address 10.1.100.28 255.255.255.0
Configuring a Default Route
Alcatel/configure> ip route 0.0.0.0 0 10.1.100.xxx
In the above example, "xxx" represents the gateway.
Switching Routing/IPMux Modes
To switch from dynamic routing mode to IPMux mode, issue the following command:
Alcatel/configure> no system routing
To switch from IPMux back to dynamic routing mode, issue the following command:
Alcatel/configure> system routing