Configure Target Discovery Using Sendtargets; Iscsi Initiator Properties - General; Iscsi Initiator Properties - Discovery - IBM DS3000 Introduction And Implementation Manual

7065iSCSI_Config3.fm

18.8.2 Configure target discovery using sendTargets

Follow these steps (on node Ora in our example), to configure target discovery using iSNS.
1. Open the iSCSI software initiator - Start → Program Files → Microsoft Software
Initiator → Microsoft Software Initiator. On Figure 18-20 on page 416, click the
Discovery tab.
Figure 18-20 iSCSI initiator properties - General
2. On Figure 18-21, click Add in the Target Portals pane to add one of the iSCSI interfaces of
the DS3300.
Figure 18-21 iSCSI initiator properties - Discovery
3. In Figure 18-17, enter the IP address or hostname of one of the iSCSI interfaces of the
DS3300. These are listed for our configuration in Table 18-1 on page 404.
416
IBM System Storage DS3000: Introduction and Implementation Guide
Draft Document for Review August 30, 2007 12:59 am