Board, Laser Unit - Sony DSC-F828 Service Manual

DSC-F828
2-8. LS-067 BOARD, LASER UNIT
1 Tapping screw
(M1.7 × 4)
Two dowels
2
4 ST laser holder
Two grooves
3
5 Remove the
6 Laser unit (D001)
three solderings
7 LS-067 board
Caution
When soldering the laser unit on the LS-067 board,
observe the following things.
(Refer to Service Note (page 1-2)).
Observe the following conditions of temperature
and time of soldering.
Temperature of soldering iron : 350 ° C
Time of contacting the soldering : 3 seconds
iron with the solder
The laser diode may suffer electrostatic breakdown
because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the
human body.
During repair, pay attention to electrostatic breakdown
and also use the procedure in the printed matter which
is included in the repair parts.
The flexible board is easily damaged and should be
handled with care.
2-7