Service Note; Note For Repair; Capacitor; Preparing The Short Jig - Sony DSC-F828 Service Manual

1-1. NOTE FOR REPAIR

Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
Cut and remove the part of gilt
which comes off at the point.
(Take care that there are
some pieces of gilt left inside)
1-2. DISCHARGING OF THE FLASH UNIT'S CHARGING CAPACITOR
The charging capacitor of the FLASH unit is charged up to the maximum 300 V potential.
There is a danger of electric shock by this high voltage when the capacitor is handled by hand. The electric shock is caused by the charged
voltage which is kept without discharging when the main power of the DSC-F828 is simply turned off. Therefore, the remaining voltage
must be discharged as described below.

1-2-1. Preparing the Short Jig

To preparing the short jig. a small clip is attached to each end of a
resistor of 1 kΩ /1 W (1-215-869-11)
Wrap insulating tape fully around the leads of the resistor to prevent
electrical shock.
SECTION 1

SERVICE NOTE

1 kΩ/1 W
Wrap insulating tape.
When remove a connector, don't pull at wire of connector.
Be in danger of the snapping of a wire.
When installing a connector, don't press down at wire of connector.
Be in danger of the snapping of a wire.

1-2-2. Discharging the Capacitor

Short circuits between the positive and the negative terminals of
charged capacitor with the short jig about 10 seconds.
1-1
DSC-F828
Short jig
(1k Ω /1W)
0 4
- 2
D D
DD-204 board