Installing The Vacuum Tubes - Toro POWERVAC 51984 Operator's Manual

Installing the Vacuum Tubes

See Figures 7 - 8.
WARNING:
Rotating impeller blades can cause severe
injury. Always stop the engine and ensure
impeller blades have stopped rotating before
opening the vacuum door or installing/changing
tubes. Do not put hands or any other object into
the vacuum tubes while they are installed on the
unit.
To install the vacuum tubes:
1. Secure the upper and lower vacuum tubes together by
aligning the raised locking tabs with the raised slots.
2. Tap tube assembly on ground until the screw holes
in lower tube are in the raised slot of the upper tube.
Secure with supplied screws. See figure 1.
3. Depress door tab using a straight screwdriver and open
vacuum inlet door.
4.
Align screw mounts on vacuum opening with screws on
vacuum tube assembly.
5. Turning clockwise, tighten screws on upper vacuum
tube to secure to main housing.
Vacuum Bag
Assembly
Vacuum
Door
Hinge
Assembly
Upper
Vacuum
Tube
To remove the vacuum tubes:
1. Loosen screws of the upper vacuum tube by turning
counterclockwise.
2. Remove the vacuum tube assembly from the main
housing.
3. Close the inlet cover door securely.
Door Tab
Vacuum Inlet
Door
Figure 7
Inlet Door
Vacuum
Opening
Screw
Screw
Mount
Figure 8
13