Engine Parts - Briggs & Stratton 11A600 Operating & Maintenance Instructions

ENGINE PARTS

3
2
1
1. Primer bulb
2. Air cleaner
3. Fuel fill
4. Finger guard
5. Spark plug wire
6. Carburetor
GENERAL INFORMATION
ENGINE MODEL
This is a single cylinder, overhead valve (OHV), air-cooled
engine. It is a low emissions engine.
In the state of California, OHV Model Series 110000 and
120000 engines are certified by the California Air Re-
sources Board to meet emissions standards for 125 hours.
Such certification does not grant the purchaser, owner or
operator of this engine any additional warranties with
respect to the performance or operational life of this engine.
This engine is warranted solely according to the product
and emissions warranties stated elsewhere in this manual.
MODEL SERIES 110000
Bore . . . . . . . . . . . . . . . . . . . . . . . . .
Stroke . . . . . . . . . . . . . . . . . . . . . . .
Displacement . . . . . . . . . . . . . . . .
MODEL SERIES 120000
Bore . . . . . . . . . . . . . . . . . . . . . . . . .
Stroke . . . . . . . . . . . . . . . . . . . . . . . .
Displacement . . . . . . . . . . . . . . . . .
Note: For practical operation, the horsepower loading
should not exceed 85% of rated horsepower. Engine power
will decrease 3-1/2% for each 1,000 feet (300 meters)
above sea level and 1% for each 10° F (5.6° C) above 77° F
(25° C). It will operate satisfactorily at an angle up to 15°.
4
5
6
2-11/16 in. (68.26 mm)
1-51/64 in. (46.00 mm)
10.20 cu. in. (167.4 cc)
2-11/16 in. (68.26 mm)
2-3/64 in. (52.00 mm)
11.58 cu. in. (189.7 cc)
6
13
12
11
7. Rope handle
8. Fuel tank
9. Oil fill/Dipstick
10. Side drain plug (if equipped)
11. Muffler/Muffler guard (if equipped)
12. Spark arrester (if equipped)
13. Engine Model
xxxxx
THE INTERNATIONAL SYMBOLS USED
ON THE ENGINE OR
IN THIS MANUAL INCLUDE:
Safety Alert Read Owner's
Manual
Stop
Fuel
TUNE-UP SPECIFICATIONS
Armature air gap . . . 0.010 – 0.014 in. (0.25 – 0.36 mm)
Spark plug gap . . . . . . . . . . . . . . . . . .
Valve clearance with valve springs installed and piston 0.1 in.
(2.5 mm) past top dead center (check when engine is cold).
See Repair Manual P/N 274008.
Intake . . . . . . . . . . . . . 0.004 – 0.008 in. (0.10 – 0.20 mm)
Exhaust . . . . . . . . . . . 0.004 – 0.008 in. (0.10 – 0.20 mm)
7
8
9
10
Type Code
xxxx xx xxxxxxxx
On Off
Oil Fuel Shutoff
Primer Choke
0.020 in. (0.51 mm)