Bit Switch; Numeric Param; How To Confirm The Setting Value - Canon MX700 Service Manual

11-3) #1 BIT SWITCH

1. After entering the #1 BIT SWITCH menu, the following screen will be displayed.
PTT PRAMETER
#1 BIT SWITCH
SW#01 00000000
2. Each time the OK button is pressed, the SW# is changed from 01 to 20.
Be careful not to enter the SW numbers which are not used in servicing.
The SW numbers which are used in servicing: SW#01, 02, 03, 04, 05, 06, 07, 10, 11, 13
The SW numbers which are not used in servicing (as of August 2007): SW#08, 09, 12, 14-20
3. Since each SW# has 8bit information, use the right or left arrow key to move the cursor to the bit to be specified and
enter the setting value (1 or 0).
Bit7 -> 00000000 <- bit0
After entering the setting value (1 or 0), press the OK button to finalize it. See the G3 Facsimile Service Data
Service Handbook for the definition and description of each bit of the SW#.
English: QY8-13BC-010
Japanese: QY8-12B6-020<>
4. After finalizing the setting value of each bit of the SW#, press the Stop/Reset button.
5. Press the ON/OFF button.

11-4) #2 NUMERIC PARAM.

1. After entering the #2 NUMERIC PARAM. menu, the following screen will be displayed.
PTT PRAMETER
#2 NUMERIC PARAM
01: 00000
2. Each time the OK button is pressed, the SW# is changed from 01 to 60.
Be careful not to enter the SW numbers which are not used in servicing.
The SW numbers which are used in servicing:
SW#01, 02, 04 to 09, 16 to 24, 26, 27, 30, 31, 41, 42
The SW numbers which are not used in servicing (as of August 2007):
SW#03, 10 to 15, 25, 28, 29, 32 to 40, 43 to 60
3. Use the right or left arrow key or numeric keypad to enter the setting value.
(The selection of the setting value varies depending on the item.)
4. After entering the setting value, press the OK button to finalize it. See the G3 Facsimile Service Data Service
Handbook for the definition and description of each bit of the SW#.
English: QY8-13BC-010
Japanese: QY8-12B6-020
5. After finalizing the setting value of each SW#, press the Stop/Reset button.
6. Press the ON/OFF button.

11-5) How to confirm the setting value

Output and confirm the PTT parameter as follows.
1. In the user mode, press the SCAN button to enter the scan mode, then press #, 9, 7, 6, 8, #.
2. PTT PARAMETER is printed automatically.
See the G3 Facsimile Service Data Service Handbook for the definition and description of each bit of the SW#.
English: QY8-13BC-010
Japanese: QY8-12B6-020
37 / 41