Remote Control - Panasonic SJ-MR220 Service Manual

1. Set the battery and connect the remote controller.
2. Turn off the power. Then, with the main unit's HOLD switch at OFF,
press the VOL+, VOL-,
controller within two seconds. (as shown in
3. When entering the main unit's key check mode, "KEY JP1" or "KEY
JP2" will be displayed on the LCD of main unit and "T KJP1" or "T
KJP2" will be displayed on the LCD of remote controller. (If it is not
displayed, perform the procedures written above again.)
4. Confirm the display of LCD by pressing any keys on the main unit.
There is no order to press the keys.
Mian unit's keys LCD display positions and letters
HOLD OFF
REC PAUSE
EDIT
STOP
PLAY
5. Remote controller's LCD [(GH) area only] lights "T
unit's LCD lights all when you can detect all keys.
6. Perform below voltage check about the keys come under if you
cannot detect the key.
Main unit's keys Check points
HOLD
REC PAUSE
EDIT
STOP
PLAY
7. When the keys are ready for detection, press the PLAY key of the

remote control.

8. Pressing each key mounted to the main body, make sure of
displayed three letters (4th ~ 6th letters) on the right side of the
, and
1st. 2nd. letters are AA
3rd. 4th. letters are BB
5th. 6th. letters are CC
7th. 8th. letters are DD
9th. 10th. letters are EE
TP403
IC501 3pin
IC501 3pin
IC501 3pin
IC501 3pin
buttons on the remote
ON OFF
0V 2.2V
0.12V 2.2V
1.96V 2.2V
1.05V 2.2V
0V 2.2V
24
Fig. 5 or Fig. 6)
" and main