Panasonic SJ-MR220 Service Manual page 19

4. When the adjustment mode is activated, "T0E1" or "T0E2" will be
displayed on the LCD of remote controller and unit [(EB, EG, GCS)
areas are displayed only unit]. After "T0E1" or "T0E2" is displayed,
select the desired adjustment item with the
of the remote controller. (If it is not displayed, perform the
procedures written above again.)
Adjustment mode
Adjustment mode
Laser power adjustment
Off-set automatic adjustment
Magneto-optical disc automatic adjustment
Playback-only disc automatic adjustment
Automatic adjustment value check
EFM jitter meajurement
REC jitter meajurement
Area setting
Open
Error rate measurement (double velocity)
Open
ROM collection check sum
DRAM check
Reliability test
Tilt measurement (disc middle speed)
PWB inspection (audio test)
*In the display of T0** ~ TF** shown above, you must adjust T0**, T1**, T2** and T3**. You must
perform the adjustment by observing the order T0**
Display
T0**
T1**
T2**
T3**
T4**
T5**
T6**
T7**
T8**
T9**
TA**
TB**
TC**
TD**
TE**
TF**
T1** T2**
19
button or
T3**.
button