Panasonic SJ-MR220 Service Manual page 23

2. Set the full-recorded magneto-optical disc with the prevention erase
situation.
3. Press the PLAY key of the remote controller ("T2**" changes to
"1AADJ" on the LCD, adjustment is started.).
4. If it has been finished normally, "1ADDJ" changes to "00OK" or
"10OK" on LCD. If it is abnormally, it changes to "10NG".
5. Press the PLAY key ("00OK" or "10OK" or "10NG" changes to "T3*
*", magneto-optical disc adjusment is finished.).
Note:
If it is displayed "10NG", check the "Troubleshooting Procedures" in the order.
6.2.5. Playback-only disc automatically adjustment
1. Have "T3**" indicated on display, and move the optical pickup to
around center.
2. Set the playback-only disc.
3. Press the PLAY key of the remote controller ("T3**" changes to
"10ADJ" on the LCD, adjusment is started.).
4. If it has been finished normally, "10ADJ" changes to "00OK" (or
"10OK") on LCD. If it is abnormally, it changes to "10NG".
5. Press the PLAY key ("00OK" or "10OK" or "10NG" changes to "T3*
*", playback-only disc adjustment is finished.).
Note:
If it is displayed "10NG", check the "Troubleshooting Procedures" in the order.
6.2.6. How to get out the adjustment mode
Remove the battery when you finish the adjustment mode.
6.3. Checking the main unit's keys
Note:
"T KJP1" and "T KJP2" are displayed only (GH) area. Other areas are not display them.
23