Troubleshooting - JVC VS-DT6 Instructions Manual

Troubleshooting

• If you are having a problem with your System, check this
list for a possible solution before calling for service.
Symptom
No sound is heard.
Poor radio reception
The CD skips.
The CD does not play.
Unable to operate the Remote Control.
Operations are disabled.
"CD NO DISC" appears.
"CANNOT PLAY" or "UNFINALIZ"
appears.
• If you cannot solve the problem from the hints given
Possible Cause
• Connections are incorrect, or loose.
• Headphones are connected.
• The antenna is disconnected.
• The AM Loop Antenna is too close to the
System.
• The FM Wire Antenna is not properly
extended and positioned.
The CD is dirty or scratched.
The CD is upside down.
• The path between the Remote Control
and the sensor on the Unit is blocked.
• The batteries have lost their charge.
The built-in microprocessor has
malfunctioned due to external electrical
interference.
There is no disc loaded.
The CD-R or CD-RW that hasn't yet been
finalized (including blank discs) has been
inserted.
here, or the System has been physically damaged, call a
qualified person, such as your dealer, for service.
• Check all connections and make
corrections. (See pages 4 to 8.)
• Disconnect the headphones.
• Reconnect the antenna securely.
• Change the position and direction of the
AM Loop Antenna.
• Extend FM Wire Antenna to the best
reception position.
Clean or replace the CD.
Put the CD in with the label side up.
• Remove the obstruction.
• Replace the batteries.
Unplug the System then plug it back in.
Insert a disc.
Insert a CD-R or CD-RW that has been
finalized.
Action
26