Presetting Stations; Auto Presetting - JVC UX-V6V Instructions Manual

Presetting Stations

You can preset up to 15 FM stations, up to 15 AM stations and up
to 15 SW stations using the Remote Control.
Note: Preset numbers may have been set to factory test frequen-
cies prior to shipment. This is not a malfunction. You can
preset the stations you want into memory by following one
of the presetting methods below.
To Manually Preset Stations————
TUNER
BAND
When changing the Band
1. Select a band (FM, AM or SW) by pressing
the TUNER BAND button.
2. Press the 4 or ¢ button to tune in a sta-
tion.
3. Press the SET button.
"SET" will blink for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns to the one set in step 2 after 5 seconds,
press the SET button again.
4. Press the UP, DOWN, >, or < button within 5
seconds to select the preset number.
UP or DOWN button: Increase or decrease the preset number
by1.
Pressing and holding the button will
continuously increase or decrease the
preset number.
> or < button: Increase or decrease the preset number
by 1.
Pressing and holding the button will
rapidly increase or decrease the preset
number.
5. Press the SET button within 5 seconds.
"STORED" appears and after 2 seconds, the display will show
you the broadcast frequency.
6. Repeat above steps 1 to 5 for each station
you want to store in memory.
To change the preset stations, simply repeat the same
steps above.
9
SET STORED
SET SET
UP DOWN
or
(Within 5 seconds)
FM = 15,AM = 15,SW = 15

Auto Presetting

(Using the Remote Control)
In each band, you can automatically preset 15 stations. The System
will automatically give each station a preset number, starting from
the lowest frequency and moving up the frequency.
TUNER
BAND
1. Select a band (FM, AM or SW) by pressing
the TUNER BAND button.
2. Press the AUTO PRESET button on the
Remote Control for more than two sec-
onds.
3. Repeat steps 1-2 for the other band.
You can change any preset station manually.
CAUTION: If the system is unplugged or a power
failure occurs, the preset stations will be stored
for about 24 hours. However, if the preset sta-
tions are erased, you will need to preset them
again.
Changing from Stereo to Mono
When you are tuned into an FM stereo broadcast, the "STEREO" in-
dicator lights up and you can hear the station in stereo.
If an FM stereo broadcast is hard to receive or noisy, you can select
Monaural mode. This may improve reception, but you will lose the
stereo effect.
Press the FM MODE button on the Remote Control so that
the "MONO" indicator lights up on the display.
FM MODE
To restore the stereo effect, press the FM MODE button on the
Remote Control so that the "MONO" indicator goes off.
AUTO
PRESET
(for 2 seconds)
MONO