Adjusting The Volume; Turning On/Off The Key-Touch Tone; Reinforcing The Bass Sound; Selecting The Sound Modes - JVC UX-A52 Instructions Manual

Adjusting the Volume

You can adjust the volume level while the unit is turned on.
The volume level has no effect on recording.
To increase the volume, press VOLUME +.
To decrease the volume, press VOLUME –.
The volume level meter appears on the display.
• The volume level can be adjusted in 41 steps (VOL MIN,
VOL 1 – VOL 39, and VOL MAX.)
• When pressing and holding the button, you can change
the volume level continuously.
For private listening
Connect the headphones to the PHONES jack. No sound comes
out of the speakers. Be sure to turn down the volume before
connecting or putting on the headphones.
DO NOT turn off (on standby) the unit with the
volume set to an extremely high level; otherwise, the
sudden blast of sound can damage your hearing,
speakers and/or headphones when you turn on the
unit or start playing any source.
REMEMBER you cannot adjust the volume level
while the unit is on standby mode.

Turning On/Off the Key-touch Tone

If you do not want the key-touch tone to beep each time
you press buttons, you can deactivate it while the unit is
turned on.
On the remote control ONLY:
Press BEEP.
• Each time you press the button, the key-touch tone turns
on (BEEP ON) and off (BEEP OFF) alternately:
BEEP ON
(Maximum)
(Minimum)
BEEP OFF
– 12 –

Reinforcing the Bass Sound

The richness and fullness of the bass sound is clearly
maintained regardless of how low you set the volume—
Active Hyper Bass PRO. You can select the bass effect
levels while the unit is turned on. The AHB PRO can be
applied only to playback sounds, and cannot be used for
recording.
To get the effect, press AHB PRO.
The AHB PRO indicator lights on the display.
• Each time you press the button, the effect changes as
follows:
AHB 1
AHB OFF
(Canceled)
AHB 1: Bass sound is clearly heard even in the low
volume.
AHB 2: Bass sound is more effective than AHB 1.
AHB OFF: Cancels the AHB PRO.
The AHB PRO indicator goes off from the
display.
To check the AHB PRO setting currently selected, press
AHB PRO once while the AHB PRO indicator is lit.

Selecting the Sound Modes

You can select one of the 4 preset sound modes while the
unit is turned on. The sound modes can be applied only to
playback sounds, and cannot be used for recording.
On the remote control ONLY:
To select the sound modes, press SOUND MODE
repeatedly until the sound mode you want appears on the
display.
The SOUND indicator also lights on the display.
• Each time you press the button, the sound mode changes
as follows:
ROCK POP
FLAT
(Canceled)
ROCK: Boosts low and high frequency.
Good for acoustic music.
POP: Good for vocal music or voice.
CLASSIC: Good for classical music.
JAZZ: Good for jazz music.
FLAT: Cancels the sound mode.
The SOUND indicator goes off from the
display.
To check the sound mode currently selected, press
SOUND MODE once while the SOUND indicator is lit.
Continued
AHB 2
CLASSIC
JAZZ