Applicable Controls - Toshiba RAV-SM566KRT-E Installation Manual

Terminal block for
Indoor / Outdoor
connecting
Terminal block for 1
wired remote
controller / central
control
Cord
clamp
Terminal cover
Earth screw
Screw
Clamp base
Screw
1 2
3
Terminal block for
wired remote
controller / central
control wiring
U U A B
3 4
Wired remote
controller wire
Cord clamp
◆ Wiring diagram
Terminal block for
Terminal block
remote controller
wiring of Indoor unit
A
A
B
B
Remote controller wire
(locally procured)
23-EN
11
Applicable
controls
2
3
REQUIREMENT
• When this air conditioner is used for the first time, it
takes approx. 5 minutes until the remote controller
becomes available after power-on. This is normal.
<When power is turned on for the first time after
installation>
It takes approx. 5 to 10 minutes until the remote
controller becomes available.
Approx. 5 minutes
"SETTING"
"SETTING"
Power on
goes out
flashes
<When power is turned on for the second (or later)
time>
It takes approx. 1 minute until the remote controller
becomes available.
Approx. 1 minutes
"SETTING"
"SETTING"
Power on
goes out
flashes
• Normal settings were made as factory default.
Change the indoor unit settings as required.
• Use the wired remote controller to change the
settings.
* The settings cannot be changed using the
wireless remote controller, simple wired remote
controller, or remote-controller-less system (for
central remote controller only). Therefore, install
the wired remote controller to change the
settings.
Remote
controller
unit
Basic procedure for changing
settings
Change the settings while the air conditioner is not
working.
(Stop the air conditioner before making settings.)
CAUTION
Set only the CODE No. shown in the following table: Do
NOT set any other CODE No.
If a CODE No. not listed is set, it may not be possible to
operate the air conditioner or other trouble with the
product may result.
*
The displays appearing during the setting process differ
Remote
from the ones for previous remote controllers
controller is
available (AMT31E). (there are more CODE No.)
Remote
4
controller is
available
6
1 5
1
Push button and TEMP.
simultaneously for 4 seconds or more.
After a while, the display flashes as shown in the
figure.
Confirm that the CODE No. is [01].
• If the CODE No. is not [01], push
erase the display content, and repeat the
procedure from the beginning.
(No operation of the remote controller is
accepted for a while after
(* Display content varies with
the indoor unit model.)
– 12 –
2
Each time button is pushed, indoor
unit numbers in the control group change
cyclically. Select the indoor unit to change
settings for.
The fan of the selected unit runs. The indoor unit
can be confirmed for which to change settings.
3
Specify CODE No. [
buttons.
4
Select SET DATA [
buttons.
5
Push button. When the display changes
from flashing to lit, the setup is completed.
• To change settings of another indoor unit,
repeat from Procedure
1
• To change other settings of the selected indoor
3
unit, repeat from Procedure
Use button to clear the settings.
To make settings after
repeat from Procedure
6
When settings have been completed, push
button to determine the settings.
When button is pushed, "SETTING" flashes
2
and then the display content disappears and the
button air conditioner enters the normal stop mode.
(While "SETTING" is flashing, no operation of the
remote controller is accepted.)
button to
button is pushed.)
] with TEMP. /
] with TIME /
2
.
3
.
button was pushed,
2
.
EN
24-EN