Table of Contents
Advertisement
Quick Links
This manual should be left with the equipment owner.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
WARNING: Do not use this unit if any part has been under water. Immediately call a qualified service technician to
inspect the unit and to replace any part of the control system which has been under water. Failure to follow this warning
could result in electrical shock, fire, personal injury, or death.
WARNING: Before performing recommended maintenance, be sure the main power switch to unit is turned off.
Electric shock could cause personal injury or death.
PROCEDURE 1—TURN ON THE ELECTRICAL POWER SUPPLY TO UNIT.
PROCEDURE 2—SELECT TEMPERATURE AND SET SYSTEM SWITCH TO DESIRED MODE.
If unit is being shut down because of a malfunction, call your dealer as soon as possible.
PROCEDURE 1—SET TEMPERATURE SWITCH TO OFF.
PROCEDURE 2—TURN OFF THE ELECTRICAL POWER SUPPLY TO UNIT.
All routine maintenance should be handled by skilled, experienced personnel. Your dealer can help you establish a standard procedure.
For your safety, keep the unit area clear and free of combustible materials, gasoline, and other flammable liquids and vapors.
Form: OG-PA1P-01
User Information Manual
Single-Package
Electric Cooling Units
NOTE TO INSTALLER
FOR YOUR SAFETY
TO START UNIT
TO SHUT UNIT OFF
ROUTINE MAINTENANCE
Fig. 1—Unit PA1P-B and PA2P
(shown with optional wire grill)
Cancels: OM01-57
Printed in U.S.A.
10-99
PA1P-B
PA2P
Catalog No. 53PA-1P4
Advertisement
Table of Contents
Related Manuals for Payne PA1P-B
Summary of Contents for Payne PA1P-B
- Page 1 All routine maintenance should be handled by skilled, experienced personnel. Your dealer can help you establish a standard procedure. For your safety, keep the unit area clear and free of combustible materials, gasoline, and other flammable liquids and vapors. Fig. 1—Unit PA1P-B and PA2P (shown with optional wire grill)
-
Page 2: Access Panel
To assure proper functioning of the unit, flow of condenser air must not be obstructed from reaching the unit. Clearance of at least 48 in. is required from top of unit and on sides except the power entry side (42 in. clearance) and the duct side (12 in. minimum clearance). MAINTENANCE AND CARE FOR THE EQUIPMENT OWNER Before proceeding with those things you might want to maintain yourself, please carefully consider the following: WARNING: 1. -
Page 3: Regular Dealer Maintenance
Complete service instructions can be found in the unit Installation, Start-Up and Service Instructions. WARRANTY CERTIFICATES Unit PA1P-B and PA2P have a limited warranty. The certificate is located at the back of this book. Be sure to read the warranty carefully to determine the coverage for your unit. -
Page 4: In Case Of Trouble
( ) If your unit still fails to operate, call your servicing dealer for troubleshooting and repairs. Specify the model and serial numbers of your unit. (Record them in this manual in the space provided.) If the dealer knows exactly which unit you have, he may be able to offer suggestions over the phone, or save valuable time through knowledgeable preparation for the service call. -
Page 5: Limited Warranty
(Units Smaller Than 185,000-Btuh Cooling Capacity) Limited Warranty ONE-YEAR WARRANTY—This Payne Heating & Cooling (herein after referred to as ALL WORK UNDER THE TERMS OF THIS WARRANTY SHALL BE PERFORMED ‘COMPANY’) product is warranted to be free from defects in material and DURING NORMAL WORKING HOURS. - Page 6 —6—...
- Page 7 Please check here if, for some reason, you would prefer not to participate in this opportunity. years years Payne Heating & Cooling If you have comments or suggestions about our product please write to: Consumer Relations Department A.
- Page 8 —8— © 1999 Payne Heating & Cooling P.O. Box 70, Indianapolis, IN 46206 OG-PA1P-01 Catalog No. 53PA-1P4...