Operating External Components With The Remote Control; Operating The Tv - JVC SP-PWS8 Instructions Manual

Operating external components with the remote control

The buttons described below are used on pages 14 and
15.
TV VIDEO
TV VOL
REC
NOTE
• Manufacturers' codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.

Operating the TV

7 To set the manufacturer's code
You can operate a JVC TV without setting the manufacturer's code.
1
Slide the remote control mode selector
to TV.
2
Press and hold F TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
TV VCR
CHANNEL
Remote control
TV
mode selector
VCR
(play button)
ENTER
Number
buttons
TV RETURN 100+
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV:
Press 0, then 7.
For a Toshiba TV:
Press 2, then 9.
Manufac-
Code
turer
JVC 01
Akai 02, 05
Blaupunkt 03
Daewoo 10, 31, 32
Fenner 04, 31, 32
Fisher 05
Grundig 06
Hitachi 07, 08
Inno-Hit 09
Irradio 02, 05
Magnavox 10
Mitsubishi 11, 33
Miver 03
Nokia 12, 34
5
Release F TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7 Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
F TV: Turns TV on and off.
TV VOL +/–: Adjusts the volume.
TV/VIDEO: Selects the input mode (either TV or
VIDEO).
CHANNEL +/–: Changes the channels.
1-10, 0, +10 (100+): Selects the channel.
TV RETURN: Alternates between the previously selected
channel and the current channel.
Manufactur-
Code
er
Nordmende 13, 14, 18, 26 – 28
Okano 09
Orion 15
Panasonic 16, 17
Philips 10
Saba 13, 14, 18, 26 – 28
Sanyo 05
Schneider 02, 05
Sharp 20
Sony 21 – 25
Telefunken 13, 14, 18, 26 – 28
13, 14, 18,
Thomson
26 – 28, 30
Toshiba 29
14