JVC RX-DP10VBK Instructions Manual page 76

To use the stored signals
When you want to use the stored signals, follow the procedure
below.
IMPORTANT:
To operate the other component(s) using this remote control—
• Aim directly at the remote sensor(s) on the target component(s).
– This remote control can send signals at a distance of 7 m (23
feet).
• You can also use the IR signal transmitter connected to this
receiver.
– Place the IR signal transmitter so that it is aimed at the remote
sensor(s) on the target component(s).
You can operate the other component(s) through the remote
sensor on this receiver.
When using the remote control:
– Set the MAIN ROOM/SUB ROOM (LEARN/TRANSMIT) selector to
"MAIN ROOM" or "SUB ROOM" correctly.
1. Set the LEARN/TRANSMIT (MAIN ROOM/
SUB ROOM) selector to "TRANSMIT (MAIN
ROOM/SUB ROOM)."
LEARN TRANSMIT
MAIN ROOM SUB ROOM
For the main room
operations
2. Press one of the source selecting buttons (or
CONTROL repeatedly) to select the desired
remote control operation mode (source).
DVD DVD MULTI PHONO
VCR 1 VCR 2 TAPE/MD
TV/DBS VIDEO FM
3. Press the desired button.
TV/CATV/DBS VCR 1
STANDBY/ON
STANDBY/ON
EFFECT
1 2 3
ROOM SIZE
4 5 6
LIVENESS
7 8 9
/P
WALL
10 0 + 10
100 +
RETURN FM MODE
Notes:
• When you press TV/CATV/DBS
operation mode selector correctly.
• To use the following buttons, you can skip step 2 above.
– VCR1 (STANDBY/ON) , TV VOL +/–, TV/VIDEO, DVD
MENU
• To use the following buttons, press DVD MENU first.
– SET, % / fi / @ / #
73
OR
LEARN TRANSMIT
MAIN ROOM SUB ROOM
For the sub-room
operations
CD
CDR
AM
PLAY
/ REW FF/
DOWN TUNING UP
REC STOP PAUSE
TV/VIDEO
TV VOL CHANNEL
SET
DVD
MENU
(STANDBY/ON) , set the TV
To erase the stored signals
After erasing the stored signals, preset signals are resumed and you
can operate JVC's components again.
1. Set the LEARN/TRANSMIT
(MAIN ROOM/SUB ROOM)
selector to "LEARN."
2. Press and hold EXIT, then press one of the source
selecting buttons from which you want to erase
the stored signals.
EXIT
and
"CLEAR" appears on the display, and all the signals stored in
the selected remote mode (source) are erased at the same time.
Notes:
• You cannot erase a signal assigned to a particular button only.
Storing a new signal to a particular button erases the previously
stored signal.
• To erase the stored signals for "CD DISC," first press
CONTROL to select "CD DISC," then press CONTROL again
while holding EXIT this time.
\
3. Set the LEARN/TRANSMIT (MAIN ROOM/
SUB ROOM) selector to "TRANSMIT (MAIN
ROOM/SUB ROOM)" to finish the erasing
procedure.
LEARN TRANSMIT
MAIN ROOM SUB ROOM
For the main room
operations
LEARN
MAIN ROOM
DVD DVD MULTI PHONO
CDR
TAPE/MD
VCR 1 VCR 2
TV/DBS VIDEO FM
LEARN
EXIT and
LEARN TRANSMIT
MAIN ROOM SUB ROOM
For the sub-room
operations
TRANSMIT
SUB ROOM
CD
AM