Ricoh 500SE Quick Manual page 12

Ricoh Caplio 500SE GPS Enabled Digital Camera — Quick Guide
menu.
3. Use the down arrow until
"Compass Calibration" is
highlighted.
4. Press the right arrow to start the
process.
5. Press "OK" to start the calibration.
6. Once the GPS LED turns red and
is blinking, start rotating the
camera on a clockwise horizontal
plane. A full rotation should take
30 seconds.
7. Perform a vertical rotation. Again the rotation should take 30
seconds.
8. If the calibration has not stopped press the "DISP" to stop
the calibration.
9. Hold the camera still; do not turn it off until the red GPS
LED stops blinking.
10. Turn the camera off—the compass is now calibrated.
11. Turn the camera back on and wait for GPS lock before
continuing.
A digital compass takes time to react to changes in direction. If
the camera changes to a different direction, it takes a few
seconds to register the change. If the compass direction is not
reading correctly or the camera have traveled more then 100
miles on a single trip the compass need to re-calibrated.
Step 7
From EKA Installation Guide
8
Ricoh Caplio 500SE GPS Enabled Digital Camera — Quick Guide
3. Press the right arrow to open the
menu.
4. Press the up and down arrows to
select on (♥) or off.
5. Press "MENU/OK" to select.
Step 6
When antiblur is enabled, the
antiblur symbol appears on the screen
Focus
Please refer to pages 64-66 of the supplied "Camera User
Guide" for additional information.
♥ = Recommended setting
The camera has 5 different focus
modes allowing the camera to
produce focused pictures in a variety
of settings. To change the focus
setting:
From Ricoh 500SE User Guide
From Ricoh 500SE User Guide
♥
From Ricoh 500SE User Guide
13