GBC Ultima 65 Service Manual page 35

6.4.2 Pull Roller Disassembly
1. Remove Feed Table.
2. Remove (4) Phillips Screws from Right Side Plate and remove Right Cover. Remove
(4) Phillips Screws from Left Side Plate and remove Left Cover.
3. Remove (3) Phillips Screws from Right Side Plate securing Upper Rear Cover.
Remove (3) Phillips Screws from Left Side Plate securing Upper Rear Cover and
remove Upper Rear Cover.
4. Remove Socket Cap Screw and Metal Sleeve from the end of Upper Right Pull
Roller. Remove Socket Cap Screw and Metal Sleeve from the Lower Left Pull
Roller.
5. Remove Right Hex Nut from Pull Roll Tension Bolt. Lift up Tension Lever to release
Pull Roll Tension Bolt. Remove Left Hex Nut from Tension Bolt. Lift up Tension
Lever to release Pull Roll Tension Bolt.
6. Remove (3) Phillips Screws from the right Idler Gear Support and remove Support
and Idler Gear.
7. Loosen (2) Set Screws on the Upper Right Chain Sprocket attached to the Pull Roller
shaft.
8. Loosen (2) Set Screws on the Motor Chain Sprocket attached to the Motor shaft.
9. Remove Upper Right Chain Sprocket and Motor Chain Sprocket.
10. Remove Pull Rollers by tilting one side up and pulling straight out.
6.0 ADJUSTMENTS
6-8