Fault Code And Check Light Flashing Lighting Identification Table - Sym MAXSYM 400i Service Manual

Fault Code and Check Light Flashing Lighting Identification Table

Fault
No.
codes
Throttle position sensor fault
1 0120
Fault detection procedures Please refer to the "EFI System components description" throttle position sensor
(TPS) chapter
Manifold Absolute Pressure sensor fault lighting
2 0105
Fault detection procedures Please refer to the "EFI System components description" manifold Absolute
Engine temperature sensor fault (water) lighting
3 0115
Fault detection procedures Please refer to the "EFI System components description" engine temperature
Engine oil temperature sensor fault (oil) lighting
4 0195
Intake temperature sensor fault
5 0110
Fault detection procedures Please refer to the "EFI System components description" intake temperature
6 1630
Fault detection procedures Please refer to the "EFI System components description" Roll over sensor chapter.
7 0130
Fault detection procedures Please refer to the "EFI System components description" O2 sensor chapter.
8 0201
Fault detection procedures Please refer to the "EFI System components description" fuel injector chapter.
9 0351
10 0230
Fault detection procedures Please refer to the "EFI System components description" fuel pump chapter.
11 0135
Fault detection procedures Please refer to the "EFI System components description" O2 Sensor chapter.
12 1505
Fault detection procedures Please refer to the "EFI System components description" idle speed control valve
Exhaust 2
13 1410
Fault detection procedures Please refer to the "EFI System components description" 2
Crankshaft position sensor fault
14 0335
Fault detection procedures Please refer to the "EFI System components description" Crankshaft position
15 1205
Fault detection procedures Please refer to the "EFI System components description" Manifold absolute
16 0603
To this chapter contents
Fault Description
Roll over sensor fault
O sensor fault
2
ＩＮＪ #1 fault
IG #1 fault
Fault detection procedures to adhere to the traditional way
Fuel pump fault
O2 sensor heater fault
ISC motor fault
nd
air solenoid valve fault
PM wire fault
EEPROM fault
This fault Please direct replacement ECU
4. Fuel Injection System
Check Check light flashing
light state
Lighting
long 0，short 6
long 0，short 9
Pressure sensor (MAP) chapter
long 1，short 2
sensor (WPS) chapter.
long 1，short 1
The current reservation
lighting
long 1，short 3
sensor (TAS) chapter.
lighting
long 1，short 5
lighting
long 1，short 7
lighting
long 3，short 3
lighting
long 3，short 7
lighting
long 4，short 1
lighting
long 4，short 5
lighting
long 4，short 9
(ISC) chapter.
lighting
long 5，short 4
chapter.
lighting
long 6，short 6
sensor chapter.
lighting long 6， short 8
pressure sensor (MAP) chapter.
Not lit
long –，short –
Parts Inspection
Throttle position sensor and wire
MAP sensorand wire
Engine temperature sensor and wire
Engine temperature sensor and wire
Intake temperature sensorand wire
Roll over sensor and wire
O2 Sensorand wire
Injector and wire
Ignition coil and wire
Fuel pump and wire
O2 Sensorand wire
Step motor and wire
nd
2 air control valve and wire
nd
air solenoid valve
Crankshaft position sensor and wire
Manifold absolute pressure sensor
and wire
EEPROM
4-43