Section 5: Slideout Systems; Transit Bars (If So Equipped); Operating The Slideout - Jayco CLASS C2013 GREYHAWK Owner's Manual

CLASS C MOTOR HOMES
Ensure that the motorhome is level before operating the slideout room. Water
leaks and other problems could result if the slideout is operated without
leveling the motorhome.
Ensure there are no people or obstructions blocking the path of the room
when it is moving. Keep away from the slide rails when the room is in motion.
The gear assembly may pinch or catch on loose clothing causing personal
injury.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
Do not place excessive weight in the slideout room. It can cause the slideout
room to malfunction and cause damage to the slideout.
The slideout room system is designed for additional floor space and comfort. The
mechanical components are gear driven. Electric powered slideout room systems
have a manual override to allow you to extend or retract the slideout room(s) in
case of a power loss. Make sure you have sufficient power available before
operating your slideout system.
T B (
RANSIT ARS IF SO EQUIPPED
IMPORTANT! Never store the slideout without the travel bars installed. This
helps seal the slideout in the closed position.
Some RVs have transit bars that need to be installed when the slideout room is in
the travel mode.
Remove the transit bars before operating the main slideout room. Be sure to install
the transit bars where indicated by label on the interior RV wall before traveling.
The following label should remain affixed permanently to the RV
SECTION 5 - SLIDEOUT SYSTEMS
WARNING
CAUTION
)
CAUTION
Fig. 5.1 Transit bar
Fig. 5.2 Transit bar label
5 - 1
: